Welcome to one of the most active flamenco sites on the Internet. Guests can read most posts but if you want to participate click here to register.
This site is dedicated to the memory of Paco de Lucía, Ron Mitchell, Guy Williams, Linda Elvira, Philip John Lee, Craig Eros, Ben Woods, David Serva and Tom Blackshear who went ahead of us.
We receive 12,200 visitors a month from 200 countries and 1.7 million page impressions a year. To advertise on this site please contact us.
Posts: 15725
Joined: Dec. 14 2004
From: Washington DC
RE: remove Cordoba GK Studio golpeador (in reply to orsonw)
quote:
I don't know why he had this on his guitar?
If you look close at the bridge you can see his pinky nail was cutting into the finish and behind the bridge. When his guitar was red you can see the wear marks in that spot as well.
Posts: 1708
Joined: Jan. 29 2012
From: Seattle, Washington, USA
RE: remove Cordoba GK Studio golpeador (in reply to orsonw)
quote:
I don't know why he had this on his guitar?
It looks like his nails have stripped some varnish from the treble side of the bridge, so maybe he sometimes had his fingers there, and below there where the plastic is, when he was using his thumb and thus the protection over the spruce. Oops, looks like Ricardo and I are in sync.
RE: remove Cordoba GK Studio golpeador (in reply to Ricardo)
hi Ricardo,
From the linked thread, I understand that the Naphtha is used to dissolve the adhesive layer and remove it with the cotton balls and cotton swabs/Q-tips.
But is the Naphtha also used to remove the Golpeador itself? How? Apply Naphtah on top of the Golpeador ? Or -at the edges- between Golpeador and the guitar?
Posts: 15725
Joined: Dec. 14 2004
From: Washington DC
RE: remove Cordoba GK Studio golpeador (in reply to Jay4Jay)
Start with pointy corners, they are easiest to pull-up. Use Q tip w naphtha on top and along edges until it gives. Use a dull knife or fingernail to start lifting until you have enough lifted to grip with thumb and fingers. As you gently pull it up keep rubbing the wet q tip underneath at contact point (side to side a straight line usually). I Usually pull off the entire golpeador as step one, releasing the tap plate from the adhesive then deal with the clean up of the the actual adhesive left on the face of the guitar using cotton balls. step one takes 20 to thirty minutes, but step two takes an hour or more if you work alone.
RE: remove Cordoba GK Studio golpeador (in reply to Ricardo)
quote:
…step one takes 20 to thirty minutes, but step two takes an hour or more if you work alone.
Step two can go a lot faster with a crew of seven.
That is, unless you use one of the road crews employed by my city, in which case you’ll have six guys in hard hats standing around watching while one guy goes at it with a shovel.
RE: remove Cordoba GK Studio golpeador (in reply to Ricardo)
Does the guitar's top need any preparation before fitting a new Golpeador? Like removing the naphtha residue, or does it evaporate?
Here the details on how I removed the golpeador and the glue. Saying big thanks to all that responded to this topic ! There may be other ways, and no guarantee this works on other /all guitars /golpeadors. Nothing guaranteed !
The golpeador itself was easily removed from the guitar. Did'nt take more than a few minutes. For this part I used a hair dryer, blowing hot air on the golpeador. With caution , it didn't need to be really hot to get the golpeador off.
Then the glue that remains sticking to the guitar top...... I used Zippo lighter fluid to dissolve the glue. Only a small amount is needed, sprayed on makeup removal cotton pads. Then I could remove the glue with my fingers. Took a total of approx. 1 hour. Two pictures attached of the removal of the glue.
Images are resized automatically to a maximum width of 800px
Printable Version
New Messages
No New Messages
Hot Topic w/ New Messages
Hot Topic w/o New Messages
Locked w/ New Messages
Locked w/o New Messages
Post New Thread