Welcome to one of the most active flamenco sites on the Internet. Guests can read most posts but if you want to participate click here to register.
This site is dedicated to the memory of Paco de Lucía, Ron Mitchell, Guy Williams, Linda Elvira, Philip John Lee, Craig Eros, Ben Woods, David Serva and Tom Blackshear who went ahead of us.
We receive 12,200 visitors a month from 200 countries and 1.7 million page impressions a year. To advertise on this site please contact us.
I have the chance to maybe move my workshop to a nicer place with more space, fresh air and a beautiful surrounding (now it’s in the cellar). The thing is that the new place has only a woodburning oven as a heater, so probably in winter there would be a fast changing temperature (warm during the day with oven, cold in the night...). It can be very cold here in winter... Do you think that would cause serious problems for guitar building? .... At least there is fresh air. Right now in my cellar on the other hand the humidity is a bit high (65-70%). What do you suggest? Move or not move? :-)
If it gets too cold at night, you could always get a small space heater with a thermostat that would keep it above a certain temperature. The more important thing would be the relative humidity, so I would make sure you have a high quality hygrometer and use a dehumidifier or humidifier as needed.
I use a wood stove as supplemental heat in the winter months up here at latitude 65.
I keep a large sauce pan, about 16” on top of the wood stove and slide it around accordingly to get more or less moisture in the shop. Most use a tea kettle.
Main heat is with a fuel oil Toyo type heater. I keep the same sauce pan next to it with a few feet of parachute cord as a wick in front of the heat outlet to introduce moisture into the shop.
Direct light is nice. Air circulation is critical for ones health. The wood stove actually sucks air into a building as a normal part of its operation.
One could, or rather should, keep a cabinet with tone woods and build assemblies where the temp and moisture are controlled for times of inactivity. I move mine into the house from the shop but only about 30 steps away when i am going out of town for more then a day.
You might have an issue with glue curing in cold temps below 50 degrees F. Sounds like you live in a temperate climate like many of us here. I tired to do my assembly phase when humidity was around 40 percent.
Printable Version
New Messages
No New Messages
Hot Topic w/ New Messages
Hot Topic w/o New Messages
Locked w/ New Messages
Locked w/o New Messages
Post New Thread