Welcome to one of the most active flamenco sites on the Internet. Guests can read most posts but if you want to participate click here to register.
This site is dedicated to the memory of Paco de Lucía, Ron Mitchell, Guy Williams, Linda Elvira, Philip John Lee, Craig Eros, Ben Woods, David Serva and Tom Blackshear who went ahead of us.
We receive 12,200 visitors a month from 200 countries and 1.7 million page impressions a year. To advertise on this site please contact us.
|
|
RE: back doming question from a beginner
|
You are logged in as Guest
|
Users viewing this topic: none
|
|
Login | |
|
Tom Blackshear
Posts: 2304
Joined: Apr. 15 2008
|
RE: back doming question from a beginner (in reply to jshelton5040)
|
|
|
quote:
ORIGINAL: jshelton5040 quote:
ORIGINAL: SEden I'm not sure where you are coming from when you say ripple. My thoughts on this is, perhaps your dish is small and tends to cut more on the sides and less on the end blocks and heal blocks? I guess that can cause a ripple. I understand now. We use a traditional taper rather than using the radiused dish to shape the sides, foot, etc. If we glue all the braces on using the radiused dish the braces don't conform to the desired arch from end to end making ripples in the back (caused by one brace being a little too high or low). It only takes a few minutes extra the way we do it and I like the looks. I'm sure I'd like the looks of yours as well it's just hard to change after doing it a certain way for so long. Hello jshelton, I put my guitar backs on free hand, which means that I can adjust to any radius for sides and length. First I will use the side depth as 1/8" difference from bottom to top. Let's say 3-7/8'' at the bottom and 3-3/4 at the top by the heel with the difference split at the waist. Then I measure with a straight edge with its side edge placed on top of the heel to the bottom end block which should raise the straight edge to about 1/2" high over the bottom block. Then I fit the back braces to the mearsurement by starting at the heel first. Using a straight edge, going across to the sides, the heel itself should not provide more than about a 1/16" clearance over the sides at the upper bout. Then I measure the middle brace about 1/32" higher, in its middle, than the brace at the heel, following the basic taper, then the third brace at the lower bout is dropped about 1/32" from the middle brace, and you should have a near perfect back dome with very little adjustment on the sides, if any, to make it fit perfectly. This will give you a gentle horizon from top to bottom and side to side. And this can be changed by hand to any measurement you wish, just by following the taper at the heel to the bottom block, and side to side clearance. You can raise or lower the dome at will.
_____________________________
Tom Blackshear Guitar maker
|
|
|
REPORT THIS POST AS INAPPROPRIATE |
Date Oct. 20 2012 12:33:46
|
|
New Messages |
No New Messages |
Hot Topic w/ New Messages |
Hot Topic w/o New Messages |
Locked w/ New Messages |
Locked w/o New Messages |
|
Post New Thread
Reply to Message
Post New Poll
Submit Vote
Delete My Own Post
Delete My Own Thread
Rate Posts
|
|
|
Forum Software powered by ASP Playground Advanced Edition 2.0.5
Copyright © 2000 - 2003 ASPPlayground.NET |
0.0625 secs.
|