Welcome to one of the most active flamenco sites on the Internet. Guests can read most posts but if you want to participate click here to register.
This site is dedicated to the memory of Paco de Lucía, Ron Mitchell, Guy Williams, Linda Elvira, Philip John Lee, Craig Eros, Ben Woods, David Serva and Tom Blackshear who went ahead of us.
We receive 12,200 visitors a month from 200 countries and 1.7 million page impressions a year. To advertise on this site please contact us.
RE: How to cut flamenco tap plates (in reply to AndrewE)
it sure is difficult.. especially if it's a thick plate like the one i got, because it will show so prominently if it is wrong. i first had the plate put on by a guitar technician, but the curve he did wasn't perfect so i took the whole thing off, and cut out a new one myself.. (crazy thing to do, i was lucky not to harm my guitar).
i used an exacto knife for cutting the sheet, as did the technician. a fresh blade is absolutely necessary. mark out with a sharp pencil first, use some curved object the help trace the curve. i used a bendable curve ruler for this. then cut along the tracing as closely as you can, just watch out for slipping. as a final step i held it in my hand and just smoothed it out a little, using the exacto blade as a shaping knife. you can't do that with a thin plate though.
RE: How to cut flamenco tap plates (in reply to AndrewE)
You could use a circle cutter for the curves that fit around the soundhole. The rest of the curves aren't that important. But I would mark them out in pencil first, just to get them the way you want them.
Anyway, whats wrong with BUYING one? Its not like they're expensive...
Jb
_____________________________
¡Si esto no está en compas, esto no es el Flamenco!
RE: How to cut flamenco tap plates (in reply to AndrewE)
I would use a knife like this. They are very sharp. Here they call it carpetknife. You can easyly cut curves, just paint the cut with a pen before doing it.
Images are resized automatically to a maximum width of 800px
RE: How to cut flamenco tap plates (in reply to AndrewE)
I'm no expert at all, having only just started to learn flamenco, but I've just fitted one to my classical. I used scissors to cut it, but my top tip is that I used Openoffice Draw (similar to the Drawing toolbar in MS Word) to design my template (based on measurements I made on the guitar), then I printed it out and checked it, then redid it on the computer and printed it out again and repeated until I was totally happy with the template - I found it took a few attempts to get the curve for the soundhole in the right place and being able to tweak it by a few mm then print out a fresh template saved a lot of time.
RE: How to cut flamenco tap plates (in reply to JBASHORUN)
It's not that I don't want to buy one, in fact that's what i've done ( 2 part tap plate self adhesive back) but the problem is the curve around the rosette is quiet different to that on the tap plate, in addition they are too long.
The tap plates are a generic shape which need to be modified to fit the specific guitar.
Printable Version
New Messages
No New Messages
Hot Topic w/ New Messages
Hot Topic w/o New Messages
Locked w/ New Messages
Locked w/o New Messages
Post New Thread