Welcome to one of the most active flamenco sites on the Internet. Guests can read most posts but if you want to participate click here to register.
This site is dedicated to the memory of Paco de Lucía, Ron Mitchell, Guy Williams, Linda Elvira, Philip John Lee, Craig Eros, Ben Woods, David Serva and Tom Blackshear who went ahead of us.
We receive 12,200 visitors a month from 200 countries and 1.7 million page impressions a year. To advertise on this site please contact us.
Okay, I can't find a flush trim router bit with a diameter smaller than 1/2".
Does anyone know where I can find one? I can't find one anywhere. Granted I'm not very internet savy, but I've been searching here and there for ~ a week, a week!!
I'd be much obliged if one of you internet gurus could point me in the right direction. I refuse to believe they don't exist. This is what I'm looking for:
Flush trim router bit diameter < 1/2" (Shaft ~1" long with ball bearing on base, to be used on routing table) Thanks in advance.
Hmm... every local hardware store around my place have 1/4 and 1/2 bits. Plus laminate trimmers only take 1/4, so I guess if a store sells laminate trimmers, there should be 1/4 bits. I bought my flush trim bit in a Home Depot.
Standard bits come in a hundred diff. sizes, but I need flush trim, with a ball bearing. I've looked in Home Depot, Lowe's, and 2 Ace Hardware's...nothing. Just "1/2; show me a pic online if you find one please.
Standard bits come in a hundred diff. sizes, but I need flush trim, with a ball bearing. I've looked in Home Depot, Lowe's, and 2 Ace Hardware's...nothing. Just "1/2; show me a pic online if you find one please.
Like I said, I bought my 1/4 Flush trim bit with a ball bearing from a Home Depot, they placed next to the 1/2 bits, on the same shelf. Ask someone over there. I actually bought a 1/2 bit without knowing the fit on my router and I had to return it in exchange of a 1/4 bit, which I did.
I don't think there is one that is made smaller than 1/2 with bearing on bottom. This is what I was told when looking for one by many stores. I've only seem them smaller with bearing on top.
Thank you Tom, that's exactly what I'm starting to believe. The bottom bearing flush bits seem to have a 1/2" minimum diameter. I could make one, but I'd rather just buy one. When I saw that Rockler's didn't have 'em, I began to lose hope.
Printable Version
.
New Messages
No New Messages
Hot Topic w/ New Messages
Hot Topic w/o New Messages
Locked w/ New Messages
Locked w/o New Messages
Post New Thread