Tom Blackshear -> RE: Wide-belt sander? (May 19 2018 15:32:50)
|
Brian, I can't imagine being without one since most of my thickness work is being done with it. Tops, sides, backs, brace material, etc. Even sanding fingerboard width, side to side on a taper, with a little jig I made. However, too wide is not necessary but to pick one that has enough width to allow you to feed rosewood through on a slant to avoid resin build-up, clogging the sand paper. I have a 37" wide Proformax double barrel, which is not necessary for this operation. I wind up using a little over half the width, sealed off with duct tape. And the second barrel I never use. A one barrel unit about 25" wide is pretty efficient. And if you are talking about a wide sander like Brune is using, then I would think your out put in guitars might not warrant the expense.
|
|
|
|