constructordeguitarras -> RE: Bone saddle thicknessing (Apr. 18 2016 4:07:46)
|
I took a piece of 3/4" MDF and made a channel in it, wide enough for a saddle blank, on my table saw and glued a piece of wood in it to keep the blank from being pushed out one end. Then I place the blank in the channel and run the whole thing through my drum sander, lowering the drum a little at a time. I did the same for nut blanks. I drum sand to very close to final thickness and do the rest by hand, rubbing the blank on pieces of sand paper lying on the bench.
|
|
|
|